Intel SSD D3-S4610 1.92TB 2.5″ SATA Enterprise SSD (SSDSC2KG019T801) – Mixed Use, 3D TLC

Mixed-use SATA endurance for write-heavier server workloads.

The Intel SSD D3-S4610 1.92TB is a 2.5-inch, 7mm SATA 6Gb/s mixed-use enterprise SSD built on Intel 64-layer 3D TLC NAND. With roughly 3 drive writes per day of endurance, power-loss protection and up to 560MB/s reads, it suits databases, logging, virtualization and other write-heavier server roles.

When Read-Intensive SSDs Are Not Enough

Databases, logging servers and busy virtualization hosts write steadily throughout the day. Read-intensive SSDs rated near 1 DWPD can wear faster than planned in these roles.

The D3-S4610 offers about three times the write endurance with the same SATA interface and form factor, so existing servers can handle write-heavier workloads without moving to a new platform.

Consistent Mixed-Workload Performance

Enterprise firmware maintains low, predictable latency during mixed read/write activity, keeping databases and VM storage responsive.

Enterprise Protection

Power-loss imminent protection, end-to-end data protection, AES 256-bit encryption and a 2-million-hour MTBF support continuous data center use.

Setup Instructions

How to Install the Intel D3-S4610 1.92TB

1. Check your server’s compatibility guidance and back up data if replacing a drive.
2. Mount the SSD in a 2.5-inch server carrier.
3. Insert it into a SATA or SAS/SATA bay; hot-plug where supported.
4. Configure the drive in RAID or as a data, log or cache volume.