The SK hynix 4GB DDR3-1333 ECC registered module is designed for servers and data-centre systems that need error-correcting memory. Its ECC design and registered buffer help keep data accurate under continuous load. Speed is rated at 1333 MT/s. Installation takes only a few minutes.
Stable memory for always-on systems.
Reliable Memory for Always-On Servers
Servers running databases, virtual machines and file services need memory that can run around the clock; a single uncorrected memory error can crash an application or corrupt data.
This 4GB DDR3-1333 RDIMM uses ECC to detect and correct single-bit errors, and its registered design reduces the electrical load on the memory controller so servers can run more modules reliably.
Specifications That Match Your System
Key specs: DDR3, 1333 MT/s, PC3-10600, 240-pin, RDIMM, 2Rx4, 1.5V. Match the memory type, form factor and speed your system supports.
Error Correction and Stability
ECC memory corrects single-bit errors automatically, which helps prevent crashes and silent data corruption in systems that run around the clock.
Setup Instructions
How to Install the Memory
- Power down the system, unplug all power cords and use an anti-static wrist strap.
- Check the system’s memory population guide for the correct slots and channel order.
- Insert each module, aligning the notch, until both retention clips lock.
- Power on and confirm the memory is detected in the BIOS or system management interface.
Reviews
There are no reviews yet.