BZBGEAR AXM764 NETGEAR-Compatible 10GBASE-LR Lite SFP+ Transceiver

The BZBGEAR AXM764 is a NETGEAR-compatible 10GBASE-LR Lite SFP+ transceiver for single-mode fiber, using a 1310nm laser and LC duplex connector for 10 Gigabit links of up to 2 km. It suits network engineers, IT teams and integrators building fiber links.

Plug in, link up.

Longer Fiber Links Without Compatibility Guesswork

Copper Ethernet stops at about 100 meters, and uncoded optics may not be accepted by the switch they are meant for.

It plugs into SFP+ ports on compatible NETGEAR switches and uses single-mode fiber to carry 10G links far beyond copper’s 100-meter limit.

Optical Specifications

10GBASE-LR Lite: 10 Gbps links over single-mode fiber. Up to 2 km reach: Connects floors, buildings and campus runs.

Installation and Compatibility

1310nm, LC duplex: Standard single-mode optics and patch cables. NETGEAR-compatible coding: Designed for SFP+ ports on compatible NETGEAR switches. Hot-swappable SFP+: Install or replace without powering down the switch.

Setup Instructions

How to Set Up the BZBGEAR AXM764 NETGEAR-Compatible 10GBASE-LR Lite SFP+ Transceiver

1. Confirm that the host port supports this module type and speed.
2. Remove the dust cap and insert the module until it latches.
3. Connect clean single-mode LC patch cables, matching the module type on the far end.
4. Check the link LED and module diagnostics in the switch or router interface.