HPE Aruba J9150D 10G SFP+ LC SR Transceiver – 10GBASE-SR, 850nm, 300m Multimode

10 Gigabit fiber links for HPE Aruba switches.

The HPE J9150D is a 10GBASE-SR SFP+ transceiver that carries 10 Gbps over multimode fiber at 850 nm with a duplex LC connector. It is designed for HPE Aruba switches with SFP+ ports (such as 2930F, 2930M, 3810, 5400R and CX 6000–8000 series), reaching up to 300 m on OM3.

Why Matching Optics Matter for Stable Fiber Links

Fiber links fail in frustrating ways when optics are mismatched: the link may not come up, may flap under load, or may log errors that slowly degrade performance. Third-party modules can also trigger unsupported-transceiver messages on HPE switches.

The J9150D follows the IEEE 10GBASE-SR standard at 850 nm, so it interoperates with any compliant optic at the other end of the link, and as a genuine HPE part it is recognized by HPE firmware without workarounds.

With a reach of up to 300 m on OM3 (400 m on OM4) multimode fiber, it suits links between wiring closets, floors and racks.

10GBASE-SR Performance and Reach

The J9150D runs at 10 Gbps using an 850 nm laser over multimode (OM1–OM4) fiber, reaching up to 300 m on OM3 (400 m on OM4) multimode fiber. Both ends of the link must use matching 10GBASE-SR optics.

Hot-Swappable with Diagnostics

The module can be inserted or removed while the device is running. Supported HPE switches report optical diagnostics such as transmit and receive power, which help find dirty connectors or damaged fiber.

How to Install the HPE J9150D

1. Confirm the host port supports 10GBASE-SR SFP+ modules and that the other end of the link uses a matching optic.
2. Remove the dust plug and slide the transceiver into the port until it latches.
3. Clean the LC connectors and connect a multimode OM3/OM4 duplex patch cord, crossing transmit and receive.
4. Verify link status and optical levels from the switch or array management interface.