HP 0950-2772 260W ATX Power Supply — Replacement for HP Kayak and Visualize Workstations

Keep legacy HP Kayak and Visualize workstations powered with the original-spec supply.

The HP 0950-2772 is a 260W ATX power supply for legacy HP Kayak XA, XA7 and XU6 and HP Visualize workstations. It uses the original HP mounting and connectors with a single internal fan. It suits engineering, lab and industrial users who keep these workstations running for specialist software or hardware.

Why Legacy Workstations Are Worth Keeping Alive

Older HP Kayak and Visualize workstations still run in labs, test benches and production lines because they host software or interface cards that do not work on modern PCs. Replacing the whole system can mean months of revalidation.

A failed power supply is one of the most common issues on these systems. Replacing it with the 0950-2772, the HP spare part for these models, returns the workstation to service without changing its configuration.

Original Fit and Connectors

The 0950-2772 uses the HP mounting and ATX connectors expected by Kayak and Visualize systems, so it installs in the original position with no modifications.

Stable 260W Output

A 260W rating supports the processors, drives and expansion cards used in these workstations, with a single internal fan for cooling.

Setup Instructions

How to Replace the HP 0950-2772

1. Shut down the HP workstation, unplug the AC cord and press the power button for a few seconds to drain residual power.
2. Open the side panel, photograph the cable routing, then disconnect the power cables from the motherboard, drives and any graphics card.
3. Remove the mounting screws or release latch, take out the old unit and install the replacement in the same position.
4. Reconnect every cable, close the case, plug in the AC cord and power on to confirm the system boots and the fan spins.