HPE 960GB SATA 6G Mixed Use SFF SC Multi Vendor SSD (P18434-B21) – 2.5″ Hot-Plug for ProLiant

Mixed-use SATA endurance for write-heavier ProLiant workloads.

The HPE P18434-B21 is a 960GB SATA 6Gb/s Mixed Use SSD in a small form factor Smart Carrier for ProLiant Gen9 and Gen10 servers. With higher write endurance than read-intensive drives and HPE firmware validation, it suits databases, logging, caching and virtualization.

When Read-Intensive Drives Wear Out Too Fast

Databases, transaction logs and caching volumes write steadily all day. Read-intensive SSDs used in these roles can approach their endurance limits early, forcing unplanned replacements.

The P18434-B21 Mixed Use SSD provides roughly three times the daily write endurance of read-intensive drives, with HPE qualification and Smart Carrier hot-plug support for ProLiant Gen9 and Gen10.

Endurance for Mixed Read/Write Workloads

Mixed-use endurance and enterprise firmware keep latency consistent under constant writes, so databases, logs and VM storage stay responsive over years of service.

Pre-Mounted Carrier for Fast Hot-Plug Service

The Smart Carrier shows drive activity and a ‘do not remove’ warning, helping technicians avoid pulling an active drive and breaking an array. The drive arrives ready to slide into a compatible bay, reducing installation time and mistakes.

Setup Instructions

How to Install the HPE P18434-B21 SSD

1. Confirm your ProLiant model supports this drive and carrier type in the HPE QuickSpecs, and update the server firmware with the Service Pack for ProLiant.
2. Insert the drive into an empty SFF bay until the carrier latches; hot-plug is supported, so the server can stay powered on.
3. Open Smart Storage Administrator or the iLO storage page to confirm the drive is detected and healthy.
4. Create a new logical drive, add the SSD to an existing array, or use it as a replacement for a failed drive.